With summer heat at its peak, the idea of hot food is a serious turnoff. Cool is where it’s at. And you can’t get much cooler than the following flowery ice bowl. It takes a little time and attention to make, as it must be frozen in several stages. However, the result is startlingly gorgeous, especially when filled with fresh summer fruit or sundry scoops of ice cream or sorbet.
Selecting your bowls
More from Zester Daily:
First, select your bowls. You’ll need two: one bigger than the other, so the smaller one will sit inside the larger. The ones I’ve used here are about 8 inches and 10 inches in diameter (20 centimeters and 25 centimeters).
If you have two metal bowls, things will go even faster, but this combo of a ceramic mixing bowl with a smaller metal one works just fine. The point is their difference in size: You’ll be filling the space between the two with water and flowers, and the space must be sufficient to make thick ice walls for your ice bowl.
Also, make sure you have space in the freezer for your two bowls sitting one inside the other. (A cue to use up all that produce frozen last summer?)
Choosing your flowers
Next go out and pick (or buy) some flowers — from your garden or terrace if you have one, or even wild ones, which give a graceful, homey touch.
The flowers should not be too big (a maximum of 1 inch across), and you’ll want to use a good mix of colors. Geraniums work beautifully, either the predominantly red and purple Pelargonium/window-box varieties or the blue or pink perennial ones. Lavender is great, as is the deep egg-yolk yellow St. John’s wort, aka Hypericum. A few rose petals won’t go amiss, and if you have some lacy, lime-green flowers of Alchemilla mollis, throw in a few of those too. Basically any small colorful flower or petal will do.
Starting your ice bowl
Pour about 1 1/2 inches (3 centimeters to 4 centimeters) of water in the bottom of the larger bowl and place a few flowers in the water. They will float around a bit, so don’t fret too much about placing them neatly and symmetrically; they will sort themselves out. In any case, this layer will be the base, so the flowers will be barely visible once you’ve filled your ice bowl. Put the bowl into the freezer and leave until solidly frozen.
Creating the bowl shape
Once the base is frozen, remove the bowl from the freezer and place the smaller bowl on top. It should sit with its rim slightly above the outer bowl, because it’s sitting on the frozen base. Make sure the smaller bowl is centered, and place a can of something heavy in it so it doesn’t float when you add more water.
Add about 1 1/2 inches of water and drop some flowers between the two bowls, poking them down a bit into the water. Freeze again. Repeat this procedure once or twice more until the water is up to the rim of the outer bowl.
The point of doing this bit by bit is to allow each layer of water and flowers to freeze firmly each time; if you poured it all in at once, all the flowers would bob up to the top, which would spoil the effect.
Once you’ve completed the process, keep the ice bowl in the freezer until needed.
Removing the ice bowl
Finally comes the tricky part — you need to get your creation out from between the two bowls. The first step is to remove the small bowl (after you’ve removed that can of something heavy). Pour some hot water (tap-hot is enough) into the smaller bowl and leave for a few moments, just long enough so you can lift it out. Now fill a sink with hot water and lower the big bowl into it. Keep testing until the ice bowl has melted enough that it’s freed itself from the sides of the bowl.
Once the ice bowl has been freed, lift it out and place on a napkin-lined tray or plate (so it doesn’t slide and/or leak).
Now you can fill it with whatever suits your fancy: a mixture of soft summer fruits or a colorful selection of ice cream and/or sorbet, for example.
Main photo: A flower ice bowl filled with summer fruit and elderflowe